Intel has discontinued its Edison, Galileo, and Joule product lines. The hardware was intended to be adopted in the IoT, wearable, embedded computing and single-board computer markets:
Intel has discontinued three of its offerings for the Internet of Things and embedded device markets.
The chipmaker said in a series of low-key product updates that it would be killing off the Edison [PDF], Galileo [PDF] and Joule [PDF] compute modules and boards over the second half of the year.
The notices mark an ignoble end for three lines that were once seen as key to Chipzilla's IoT and connected appliance strategies.
First unveiled at the 2014 CES show as a "PC on a card," Edison's aim was to put x86 chips into both the wearables and "maker" markets with kits and hobbyist boards (like the Arduino).
Additional coverage on hackaday.io with one interesting note:
It's important to remember that this does not mark the end of the semiconductor giant's forray into the world of IoT development boards, there is no announcement of the demise of their Curie chip, as found in the Arduino 101. But it does mark an ignominious end to their efforts over the past few years in bringing the full power of their x86 platforms to this particular market, the Curie is an extremely limited device in comparison to those being discontinued.
(Score: 2) by Soylentbob on Wednesday June 21 2017, @04:18AM
That's just a matter of where to put the chip. If you use it instead of the heat-wire, you should be fine.