Stories
Slash Boxes
Comments

SoylentNews is people

posted by Fnord666 on Wednesday January 31 2018, @12:50AM   Printer-friendly
from the under-pressure dept.

Submitted via IRC for AndyTheAbsurd

It's called Spark Controlled Compression Ignition, and Mazda made it work.

Despite rumors to the contrary, the internal combustion engine is far from dead. Recently we've seen several technological advances that will significantly boost the efficiency of gasoline-powered engines. One of these, first reported back in August 2017, is Mazda's breakthrough with compression ignition. On Tuesday, Mazda invited us to its R&D facility in California to learn more about this clever new Skyactiv-X engine, but more importantly we actually got to drive it on the road.

The idea behind Skyactiv-X is to be able to run the engine with as lean a fuel-air mixture (known as λ) as possible. Because very lean combustion is cooler than a stoichiometric reaction (where λ=1 and there is exactly enough air to completely burn each molecule of fuel but no more), less energy is wasted as heat. What's more, the exhaust gases contain fewer nasty nitrogen oxides, and the unused air gets put to work. It absorbs the combustion heat and then expands and pushes down on the piston. The result is a cleaner, more efficient, and more powerful engine. And Skyactiv-X uses a very lean mix: a λ up to 2.5.

Source: https://arstechnica.com/cars/2018/01/mazdas-skyactiv-x-shows-the-internal-combustion-engine-has-a-future/


Original Submission

 
This discussion has been archived. No new comments can be posted.
Display Options Threshold/Breakthrough Mark All as Read Mark All as Unread
The Fine Print: The following comments are owned by whoever posted them. We are not responsible for them in any way.
  • (Score: 2, Interesting) by Anonymous Coward on Wednesday January 31 2018, @03:13AM

    by Anonymous Coward on Wednesday January 31 2018, @03:13AM (#630808)

    > If one of these sensors fails, can the engine run at all?

    Might have a limp home mode in the software that runs things from an open loop calibration table? But certainly can't run well without the feedback sensor, everything in this engine is on the edge.

    Another possible failure mode is a sticky/leaky fuel injector -- too much fuel combined with 16:1 compression is going to make a bigger bang than the materials of the engine can withstand (for very long).

    Starting Score:    0  points
    Moderation   +2  
       Interesting=2, Total=2
    Extra 'Interesting' Modifier   0  

    Total Score:   2