SoylentNews is people
SoylentNews is powered by your submissions, so send in your scoop. Only 17 submissions in the queue.
SoylentNews
Announcing the Raspberry Pi PoE+ HAT
The Raspberry Pi Foundation has just announced the Raspberry Pi PoE+ HAT compliant with 802.3at (aka PoE+) and 802.3af standards and support for up to 25.5 Watts input.
It will replace the Raspberry Pi PoE HAT introduced in 2018 which was limited to 802.3af standard with a maximum of 15.4 Watts input and will become available around mid-June for $20 plus taxes and shipping.
HAT = Hardware Attached on Top.
Here is a competing Waveshare PoE HAT for Raspberry Pi 3B+/4B.
Also at CNX Software.
This discussion has been archived.
No new comments can be posted.
Raspberry Pi Foundation Announces a New Power Over Ethernet HAT
|
Log In/Create an Account
| Top
| 19 comments
| Search Discussion
The Fine Print: The following comments are owned by whoever posted them. We are not responsible for them in any way.
Cole's Law:
Thinly sliced cabbage.
(Score: 3, Interesting) by DannyB on Monday May 24 2021, @09:30PM (3 children)
It seems like a cluster would have other means of getting more power to an RPi.
Consider an RPi application such as a security camera. The RPi has a camers, a clear plastic case shaped like a camera with a nice lens. Some local storage for booting. It shore would be nice if you could connect such a security camera by stringing only a single wire (PoE) to these cameras.
I wonder how much power would be needed if the camera were on a motorized swivel that could be rotated by the guards between donut breaks.
The thing about landline phones is that they never get lost. No air tag necessary.
(Score: 4, Interesting) by Booga1 on Monday May 24 2021, @09:36PM
This new HAT supports 25 watts, The Raspberry Pi is about 12 and I have a motorized WiFi "smart" camera that takes 12v 1 amp, so 12 watts tops. Looks like this would be just about perfect with the right camera setup, but...a dedicated PoE "smart" camera would already be pretty close to everything you need anyway. I'm thinking this might be better suited to something more complicated than a camera install.
(Score: 0) by Anonymous Coward on Monday May 24 2021, @10:27PM
Switch to RPi0w with Camera mount. Then get PoE Texas external - roughtly the size a "W". Will need a USB-Ethernet. Break the cases and switch to direct wiring. 3D print housing. Use solenoid from a model plane and connect to the pin-out. Total parts retail about $40 plus camera. PoE and solenoid is largest cost.
Use Cat-7 Flat wire, so very soft to bend. Done.
PoE give you about 12-15W total available power. W uses less than 4B, USB-Ethernet will use a little from the W and solenoid will too. But overall the power envelope should be good.
Better get a PoE camera. IT only used 4 out the 8 wires. The "other" 4 could be "reused" to run a small stepper motor, directly wired. Then it is single run. Camera and basic swivel controls. or 2 direct drive dc motors one on each lead. then you can pan and tilt.
All that fun for a weekend!
(Score: 0) by Anonymous Coward on Monday May 24 2021, @11:08PM
That can depends on the cluster and its design envelope. It isn't considered completely crazy to have smaller or denser clusters made of low power devices to be PoE. It saves on doubling your wire requirements and simplifies setup, among a couple smaller benefits.