SoylentNews is people
SoylentNews
Libreboot Sees First New Release In Nearly 5 Years, Supports More Old Motherboards
Libreboot as the Coreboot downstream focused on providing a fully open-source BIOS/firmware replacement without any black boxes / binary blobs is out with a new release. The prior tagged release of Libreboot was all the way back in 2016 while has now been succeeded by a new release albeit in testing form.
Libreboot 20210522 allows more Intel GM45 / X3X era hardware to work with this fully open-source alternative to proprietary BIOS/UEFI firmware. New boards supported by this Libreboot release include the Acer G43T-AM3, Lenovo ThinkPad R500, Lenovo ThinkPad X301, and Intel G43T-AM3. Yeah, it's quite hard in 2021 to get excited about Socket 775 motherboards or 45nm Penryn laptops. Libreboot is largely limited to supporting these outdated platforms due to its focus on being fully open-source and not using any Intel FSP binaries, etc.
Previously: Replace your Proprietary BIOS with Libreboot
AMD to Consider Coreboot/Libreboot Support
Libreboot Applies to Rejoin GNU
(Score: 2) by bzipitidoo on Tuesday May 25 2021, @09:08PM (1 child)
Thank you for the correction. I had thought the extra wires were just there as a shield, not as a ground. Explains why it's 80 wire, and not 79 or 81 wire. Also explains how the connector can still be only 40 pin.
(Score: 0) by Anonymous Coward on Wednesday May 26 2021, @05:17AM
I imagine the choice of 80 wires is more a practical choice than anything else. For example, presumably there is no real point in adding an extra ground wire between pins 1 (reset) and 2 (ground). These wires are right next to each other with nothing between them so there is unlikely to be problems. And the other side of the cable already has several ground wires interspersed with various (mostly non-critical) signals, with nothing as obviously horrible as the data lines.
The practicality just comes from "hey, we can just use off the shelf 0.635mm ribbon cable and off the shelf tools to terminate into special connectors, then we only need to design/build those connectors and there's barely any change to manufacture the cable assemblies". Then the geometry of ribbon cables basically makes 80 conductors the only option -- 79 would presumably do just fine but the ribbon would be off-center and the factory probably wouldn't like it as much (I have seen ribbon cables terminated this way, however).
As an aside, there was a brief period when round IDE cables were available. I doubt any of these actually had 80 wires since the point of these cables was to have a "clean" look in your case, but I suspect they would nevertheless perform quite well (despite the ATA standards only specifying the use of ribbon cables) as the round design inherently brings everything physically closer together.